I Nstalli Ng The Fence; Removi Ng The Fence - RIDGID R4550 Operator's Manual

To remove the Blade Guard Assembly:
1.
Lift the Lock Tab to the unlocked position.
E
2.
Rotate the Guard back and slide the Locating Pin
the Riving Knife slot.
See Figure 23.

I NSTALLI NG THE FENCE

The fence can be positioned on one of the three pairs of tabs.
Two on the right side of the blade and one on the left side.
1.
To engage the fence, hold it at an upward angle while
engaging the desired tab pair into the front and rear fence
notches.
2.
Lower the fence until the two latches engage the fence
rails.
See Figure 24 and 25.

REMOVI NG THE FENCE

1.
Lift the orange latches
Fence.
2.
Tilt the Fence up at a slight angle.
3.
Disengage notches on Fence System from tabs on rail.
See Figure 26. To see Fence installed refer to page 3.
ASSEMBLY
from
C
on the on the sides of the
F
C
F
20
E
Figure 23
Figure 24
Figure 25
Figure 26