Advertisement
CP-SX5600W
1. Features
0.9 inches reflecting type liquid crystal panel use.
High brightness, High resolution.
RS-232C communication.
Complies with VESA DDC1/2B specifications.
Right and left reversal, vertical reversal function.
2. Service points
Instruction for cleaning the dust from panel and optical filter
1. Preparation
Please prepare these cleaning materials tools. And, prepare relatively clean room not to work in additional dust,
while removing operation.
1) Swab for cleaning ....P#NX08061, "Cotton stick L147"
2) Air duster (Dust blower, spray can type)
3) Vacuum cleaner
4) Remote control unit for CP-SX5500W/CP-SX5600W
2. Disassemble
1) Please refer to service manual. CP-SX5500W Service Manual YK No.0517E
On the manual, page 16,17,and 18 shows the way to disassemble the set.
2) Remove the upper case and PWB ass'y MAIN.
3) In this case, please attach the "Lamp door" (Page18)and connect two cables(EPOW and EFN1)(Page27).
4) Remove duct cover and packing as shown in Fig 1.
Rivets x2
Duct cover
Note: In early production, duct cover was attached by tape instead of rivets.
2
Fig.1 Removing duct cover and packing
Screws x3
Packing x3
Advertisement
