0" Key Button; Keys; Freq"Uency Button; Lcd Display - DIGITECH Audio AR-1733 Owner's Manual



"0" KEY Button

The button can be pressed and held for two seconds to change MW step at 9kHz
and 10kHz.


"FREQ"UENCY Button

This button is used to enter a frequency directly. You have to be in the radio band
of your choice before you enter a frequency.
Quickly pressing the button enters 0~9 number keys directly with the radio "on".
For FM,you have to enter a last digit. To enter 107.5 FM,you must press "FREQ"
and then press 1-0-7-5,and then press "FREQ" once again.
For LW and AIR band, you can enter a frequency using 0~9 numbered keys.
AM and SW is straightforward. Press "FREQ" and enter the AM or SW frequency
using the numbered keys.
While the radio is off, press and hold the button for 3 seconds to enter
time setting. Whatever in 12 or 24 hour format, you must enter the numbered
keys to set time in 24 hour format. Example: press "8",display "08:_ _".
If default in 12 hour format, it will change to 12 hour format automatically.


0-9 KEYS

There are used to directly enter a frequency or memory channel. See above 'FREQ'
-UENCY button for direct entry with the radio "on".
Directly enter the numbered key (0~9),recall the frequency on "CH0~9" with the radio
"on".
Press and hold any one number key for three seconds to save the entire frequency on
corresponding number channel. Example: show "96.10MHz" in the LCD now, press
number "5" for three seconds,then the radio will memorize "96.10MHz" to "CH 5" on
current page.


LCD DISPLAY

Learning the features and the corresponding display icons can make your radio easier
to use.
13