Table of Contents
Advertisement
1
1.2 Systems Covered
1.3 Installing an ESD Kit
1.4 Installation Cautions
!
1-2
The installation procedures described in this guide cover the following Sun
systems:
•
SPARCstation 1 and 1+
•
SPARCstation IPC
•
SPARCstation IPX
•
SPARCstation 2
•
SPARCstation 10 and SPARCserver 10
•
SPARCclassic
•
SPARCstation LX
•
SPARCsystem 630MP
•
SPARCsystem 670MP
•
SPARCserver 690MP
•
SPARCcenter 1000
•
SPARCcenter 2000
Refer to Section 2.4 for System Requirements.
The ESD (electrostatic discharge) kit includes the following:
•
ESD kit which consists of an antistatic mat and a wrist strap. The wrist strap
is a disposable one piece design which attaches by adhesive to electrical
ground and the installer.
Carefully read and follow the cautions below before beginning the installation
procedure. Failure to comply may result in damage to the equipment.
Caution – Do not open the antistatic envelope containing the
TurboGX/TurboGXplus card until instructed to do so.
TurboGX/Turbo GXplus Installation Guide—November 1993
Advertisement
Table of Contents
