baby&child Emelia Queen Quick Start Manual

Canopy bed

Advertisement

WARNING: ADULT ASSEMBLY ONLY OWING TO THE PRESENCE OF SMALL
PARTS, SHARP POINTS AND EDGES
Customer Service- If you are missing parts or have any questions about this product,
please contact us at : 1-800-762-1751

CARE INSTRUCTIONS

Dust often using a clean, soft, dry lint-free cloth.
Blot spills immediately, and wipe with a clean, damp cloth.
We do not recommend the use of chemical cleansers, abrasives, or furniture polish
on our lacquered finish.

PART LIST

A [1] HEADBOARD PANEL
B [2] SHORT CANOPY POSTS
C [2] LONG CANOPY POSTS
D [1] FOOTBOARD PANEL
E [2] SIDE RAILS
F [1] SLAT ROLL
G [2] SHORT CANOPY RAILS
H [2] LONG CANOPY RAILS
I
[4] CANOPY FINIALS - LARGE
J [5] SUPPORTS LEGS

HARDWARE LIST

ASSEMBLY INSTRUCTIONS

Note: Bed can be assembled by one person rather easily, but if two people are available it is easier and
the operation will require less preparation. The instructions are written assuming one person is
assembling the bed.
1. Place the Headboard (A) upright in the position you wish the bed to be in when fully assembled. The
headboard bed fast hardware should be facing the inside, toward the mattress.
The Side Rails (E) are not handed parts so either rail will work on the right or left side. While holding the
Headboard (A) up, place the hooks in the rail into the slots in the post of the headboard. If necessary, using a
thick magazine or book to protect the side rails, hammer the hook-rail with a mallet or hammer until tight.
TOOLS NEEDED
- Rubber/wood Mallet or hammer
- Book or magazine
- Screwdriver
6 x14mm
8x30mm

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Emelia Queen and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for baby&child Emelia Queen

  • Page 1 WARNING: ADULT ASSEMBLY ONLY OWING TO THE PRESENCE OF SMALL PARTS, SHARP POINTS AND EDGES Customer Service- If you are missing parts or have any questions about this product, please contact us at : 1-800-762-1751 CARE INSTRUCTIONS Dust often using a clean, soft, dry lint-free cloth. Blot spills immediately, and wipe with a clean, damp cloth.
  • Page 2 Repeat the procedure with the other rail. The Headboard Panel (A) will now stand on it's own with the rails supporting it. Insert the side rail hooks into the slots in the Footboard (D) and use the method described above (as shown in diagram 1). Tighten the Support Legs (J) to the Slat Roll (F) (as shown in diagram 2).
  • Page 3 Diagram 5 Diagram 6 ASSEMBLING THE BED WITHOUT THE CANOPY Secure the Canopy Finials - Large ( to the top of canopy posts.

Table of Contents