Table of Contents
Advertisement
Intensity of the Backlight
9.4
•
Go to "System settings" -> "Maintenance" .> "Display settings" -> "Back-
light brightness" to adjust the intensity of the backlight according to the
environmental light conditions.
Touch Screen Calibration
9.5
•
The touch screen is factory calibrated and a readjustment is normally not
necessary. If a touch is not recognized at the place it should, a readjust-
ment might correct it.
•
•
•
Communication Interface
9.6
Factory default setting for the communication with the optional NovalogMC
software is the USB interface
Note: USB functionality is implemented in NovalogMC version V2.20 and higher
•
Please change settings as follows if a communication via RS-232 interface
is required. Go to "System settings" -> "Maintenance" -> "Interface for
computer connection" an choose RS-232
Password Protection of "Chamber settings" und "System settings"
9.7
•
Go to "System settings" -> "Maintenance" -> "Set system password" to
enter a password to protect menus from unauthorized access
•
Password can contain a maximum of 12 characters. Upper and lower case
will be differentiated
•
A set password will be activated once user returns to main screen after
setting the password.
•
Password protection will be deactivated by going to menu "Set system
password" and do not enter anything in the editor. Just let the input box
"Please enter new password".
•
A forgotten password can only be resetted by Novasina
Reset a forgotten or lost password
•
Go to "System settings" -> "Maintenance" -> "Set system password" and
enter GET CODE in the input box "Please enter system password!"
•
A pop-up appears with a specific code which has to be sent to your No-
vasina agent.
•
You will get a new code back which you can enter if you answer the Reset
system password query with "Yes"
•
The reset code from Novasina remains valid until password is reseted
or once athe valid code has been entered. It is a single-use code, thus if
password is forgotten again, a new code has to be ordered.
•
Note: Requesting a new code comes with costs.
Go to "System settings" -> "Maintenance" -> Display settings..."
->"Adjust touch panel"
Touch the screen at exactly those positions indicated with a cross.
Use a soft-tip pen (no ball-pen)
The system accepts the adjustment only, if you touch the white area
within 30 seconds after activation of the last cross.
29
- Quick Links:
- Maintenance
Hide quick links:
Advertisement
Table of Contents
