Additional Functions; Reset To Default Values - Novasina LabTouch-aw Operating Instructions Manual

9.

Additional Functions

Change Acoustic Signals
9.1

Reset to Default Values

9.2
Update of the System
9.3
28
This chapter describes all the additional functions as system settings which
can be found in the menu structure of the LabTouch-aw.
• Go to "System settings" -> "Acoustic signals..." and select one of the
options to adjust the acoustic signal:
• "Key beep"
Switch on or off the haptic key feedback.
• "Duration stability signal beep"
Enter the duration of the beep which is issued if stability is reached.
If you want to switch off the beep, just delete any entered value.
Chose "System settings" -> "Maintenance..." -> "Reset to factory settings"
->[Yes], ->[No] to set the instrument back to factory default values.
Note:
• The storage of the last 10 stable measurement values will be deleted as well.
• The calibration values and other data (i.e. sensor password) stored on the
sensor will remain and are not deleted by this process.
Updates of the firmware are distributed by Novasina representatives. Once you
got the update file, copy the folder "Update" into the main directory of the SD-
card by using a PC. Please do not compress it to a .zip, just use the file as it is.
• Please double-check, if the folder contains three different files: "LabTouchC.
bin", "LabTouchM.bin" and "LabTouchS.bin"
• Go to "System settings" -> "Maintenance" -> "System update" and con-
firm with [YES].
• The update is performed in various steps. Please note that the system is
restarted during the update process. Do not touch anything or discon-
nect anything during this procedure!
Note:
• The system is designed in a way that an update can be re-initialized in
case it is aborted by incident (i.e. loss of power etc.)..
• Please use only files which are distributed by your official Novasina repre-
sentative. The use of other files can irreversibly damage the instrument
and cause loss of warranty.