Disclaimer - Baudcom BD-5800H Operating Manual

flash red
Laser TEC
OutPutPower Status HIGH
None

6.3 Disclaimer

We reserve the right to change any products described herein at any time, and without
prior notice. We assume no responsibility or liability arising from the use of the
products described herein, except as expressly agreed to in writing by us. The use and
purchase of this product does not convey a license under any patent rights, copyrights,
trademark rights, or any intellectual property rights of us. Nothing hereunder
constitutes a representation or warranty that using any products in the manner
described herein will not infringe any patents of third parties.
Website: www.baudcom.com.cn Tel：+86-21-37709251 Email: info@baudcom.com.cn
1550nm external modulated optical transmitter operating manual
HIGH
(LOW)
None
- 25 -
Verify that the unit is operating
within the proper temperature
range (-5～+45℃).
Verify that nothing is
obstructing airflow through the
openings in the front and back
The laser is off of the unit.
Recall factory settings by
pressing the key on the front
panel (see Section 3).
If that does not correct the
problem, contact Customer
Service.
Reboot the equipment. If that
The laser is off does not correct the problem,
contact Customer Service.
Check the fiber connector.
The optical output Follow the connector cleaning
power is lower procedure (see Section 6.1).
than the nominal If that does not correct the
value problem, contact Customer
Service.