Remote Monitoring: Snmp - Baudcom BD-5800H Operating Manual

ethcfg
This command configures the Ethernet parameters, including IP address, subnet mask
and gateway. You can refer to the help information for its using.
settrap
This command shows or modifies the aim host IP address list of the SNMP Trap,
IP address of 0.0.0.0 and 255.255.255.255 don't exist. SNMP Trap does not send to
these two addresses.
community
This command configures the read-only group name and read-write group name.
"Group name" is the concept of SNMP agreement like the password. Use the
command "community ro" to configure the read-only, and "community rw" for the
read-write. For example, input "community rw public", "public" is the read-write
group name. The group name for read-only and read-write are both "public" as the
equipment default setting from factory.

5.4 Remote Monitoring: SNMP

LAN communication interface
Adopt RJ45 standard connector, the pin definitions as follow:
1: TX+
2: TX-
3: RX+
4: No Connect
5: No Connect
6: RX-
7: No Connect
8: No Connect
A: Green indicator flashing means that the LAN port is sending data.
Website: www.baudcom.com.cn Tel：+86-21-37709251 Email: info@baudcom.com.cn
1550nm external modulated optical transmitter operating manual
- 20 -