Mounting The Equipment; Mounting The Equipment In The Rack; Connecting The Rf Cables; Connecting The Optical Fiber Cables - Baudcom BD-5800H Operating Manual

Warnung

4.3 Mounting the Equipment

Mounting
4.3.1
Mounting the
Equipment
1. Place the equipment in the rack.
2. Use four screws fixed the mounting lug on its front panel to the rack.
3. Reliably ground the equipment. The ground terminal is on the rear panel.
4. Visually inspect each key (button) on the front panel to ensure that it is not trapped
under the edge of its hole. If a key is trapped, tap the key to enable it to move freely.

4.3.2 Connecting the RF Cables

Verify the RF input F connector type according to the ordering information, then
screw on the matched RF cable.

4.3.3 Connecting the Optical Fiber Cables

It has two output optical connectors.
DANGER:
1. Verify the matched its fiber cable connector type according to the ordering
information.
2. Verify that the fiber cable connector has been cleaned properly. If the fiber cable
connector needs to be cleaned, follow the cleaning procedure outlined in "Cleaning
Patch Cord or Pigtail Fiber Optical Connectors".
3. Verify that the optical connector has not been exposed to any contamination.
NOTE: Any contamination of optical connector can significantly degrade
optical link performance. This degradation will most likely
manifest itself as poor signal-to-noise (SNR) performance.
4. Note to butt the nick of the connectors and align them accordingly.
Website: www.baudcom.com.cn Tel：+86-21-37709251 Email: info@baudcom.com.cn
1550nm external modulated optical transmitter operating manual
Mit Wechselstrom betriebenes Modell: Der Netzstecker muss
jederzeit leicht zugänglich sein.
Equipment
the
in the standard 19 inch equipment rack:
The fiber carries invisible laser radiation. AVOID DIRECT
EXPOSURE TO BEAM. Never operate the unit with a
broken fiber or with a fiber connector disconnected.
- 14 -
in the
Rack