Resources 资源; Gain Staging 101 (电平匹配管理): Begin At The Beginning 从 头 开 始 - PRESONUS Revelator io24 Owner's Manual

9 Resources
9.1 Gain Staging 101: Begin at the Beginning
9
Resources
资源
9.1
Gain Staging 101: Begin at the Beginning
Step 1: Setting the Microphone Gain 设置麦克风增益
增益分期101：从头开始
It may seem counter intuitive to boost the signalclosest to its source and
cut it later in the signal path if it is too loud, but this is precisely the best
way to get a noise- and feedback-free recording. That said, you don't
want to gain it up too much at the beginning either. If you find that you
must cut the signal at every componentthat sits after the input-trim stage
to avoiddistortion, you've probably set the trim too high. Then, and only
then, should you gain it down. 提升最接近信号源的信号，并在信号路径
的后面削减它，如果它太响的话，这似乎是违反直觉的，但这正是获得无
噪音和无反馈的录音的最佳方法。也就是说，你也不想在一开始就把它增
益得太高。如果你发现你必须削减信号在 如果你发现你必须在输入调整
阶段之后的每一个组件上切断信号以避免失真，你可能已经把调整设置得
太高了。那么，也只有在这个时候，你才应该把它增益下来。
First,pluginyourmicrophoneintoyourdesiredChannelinputandactivate+48vif
your mic requires it. Put on your headphones and listen.
首先，把你的话筒插入你所需要的通道输入，如果你的话筒需要的话，激活
+48v。戴上耳机，听一听。
TurntheEncoder knobclockwise while speaking intothe microphone.Watching
for the signal/clip indicator to turn red, then back it down until the level indicator is
green only...
在对着话筒说话的同时顺时针转动编码器旋钮。观察信号/夹子
指示灯变成红色，然后将其调回，直到电平指示灯变成绿色......
Revelator io24
Owner's Manual
122