Panasonic MC-BJ980 Operating Instructions Manual page 15

Cleaning the Power Nozzle
Check the areas marked in the illustrations and
remove any debris.
Cut off any hair, thread, string, carpet pile, and
lint entangled around agitator with a pair of
scissors.
Cleaning Agitator
1
To remove the agitator cover and agitator:
① T urn the latch located on the agitator cover
to the unlock position.
② Press the shutter down.
Remove agitator cover.
③ Press the shutter down.
Lift the agitator end cap out.
④Remove agitator.
⑤Remove belt.
1
2
4
5
3
2
Remove any dirt or debris in the belt path and
agitator areas.
3
Wash with cold water, then dry completely.
4
To install agitator cover and agitator:
①Reinstall belt onto belt pulley.
②Reinstall agitator into nozzle as shown.
③Press agitator end cap into place in nozzle.
④ Press the shutter down.
Fit the tip of the agitator cover by hooking
the claw.
⑤ Place the agitator cover onto nozzle and
secure by rotating the latch to the lock
position.
5
3
1
2
4
EN13