Configuration > Output - Qeedji DMB 400 User Manual

3.1.4 Configuration > Output
pane, select the Output menu to configure, among other things, the unit' s video and audio output.
From the
Configuration
:
Screen resolution
: 96x96 to 3840x2160.
Resolution
: SMPTE, VESA, CEA-861, SONY, SAMSUNG, CGV CPLine AV-HD, PC, DENSITRON, XGA, LESTEL, LINSN, ...
Mode
: 25 Hz, 30 Hz, 45 Hz, 60 Hz, 50 Hz.
Freq uency
:
Overscan
720p SMPTE,
1080p SMPTE,
2160p SMPTE,
Personalized:
: horizontal origin of the viewport in pixel,
X
: vertical origin of the viewport in pixel,
Y
: width of the viewport in pixel,
Width
: height of the viewport in pixel.
Height
: 0°, 90°, 180°, 270°.
Rotation
: on (vertical sync standby on) or off (vertical sync standby off) ¹ .
VESA DPMS
: AUDIO JACK35 L+R.
Audio output
option : allows to activate or deactivate the sound card:
Sound card
: 0..100%,
Volume
option : on (mute) or off (mute on).
Mute
☛ The rotation is not supported for resolutions higher than 1920x1080.
☛ Some screens may not support certain display modes. In this case, try another mode with the same resolution.
☛ When supported by your screen and your device, if possible use a 60 Hz mode which is the smoothest mode for scrolling text.
¹ VESA DPMS sleep and standby output is performed either by a screen sleep task programmed into an App, or by a power management task
with the
strongly optimized
Some screen, due to their construction, have been designed with an overscan, which means that the edges of your broadcast content on your
device may not be visible on your screen even when choosing the right optimal resolution for your screen. To alleviate this problem, use the
overscan on your
Qeedji
pattern of the device.
When using the overscan, for a good configuration of your device, please make sure that your screen is not in
◬
mode.
device to slightly reduce the width and height of your viewport. While doing so, it is recommended to display the test
26
, or mode.
Wall Mozaic Tile