Qeedji DMB 400 User Manual page 13

• Step 3: Nominal mode
State
Green blinking: 1 very
short flash (300 ms)
spaced 4 seconds
apart
Green blinking: 2 very
short and consecutive
flashs (300 ms)
spaced 4 seconds
apart
Green blinking: 3 very
short and consecutive
flashs (300 ms)
spaced 4 seconds
apart
Green blinking: 4 very
short and consecutive
flashs (300 ms)
spaced 4 seconds
apart
Green blinking: 5 very
short and consecutive
flashs (300 ms)
spaced 4 seconds
apart
Green blinking: 6 very
short and consecutive
flashs (300 ms)
spaced 4 seconds
apart
Green blinking: 7 very
short and consecutive
flashs (300 ms)
spaced 4 seconds
apart
Off
¹ If the problem persists in despite of an appropriate power-supply, contact
² If the problem persists, it is recommended to find out the media not supported yet by the system and remove it from content.
³ If the problem persists after a partition repairing, contact
Information
OK
Warning: Fail Soft Mode Level 1
Frequent device reboot detected (for example 4 times in less than ½
Message is displayed on the screen: « Fail Soft Mode: waiting for new content » .
The instability has been caused probably by a content media not supported yet by the Gekkota OS. Consequently, to
prevent any further reboot, the content has been invalided. The message displayed on the screen indicates that a
new publication is needed to go ahead. ²
Warning: Fail Soft Mode Level 2
Frequent device reboot detected (for example 4 times in less than ½
Content is purged
Message is displayed on the screen « Fail Soft Mode: waiting for new content » .
The instability has been caused probably by a content not supported yet by system or one user preference which
has been modified. Consequently, to prevent any further reboot, the content has been invalidated and user
preferences (saved before unexpected reboot) have been restored. The message displayed on the screen indicates
that a new publication is needed to go ahead. ²
Warning: Check disk
The device has detected memory corruption on content storage. The media storage is being repaired. This repair
step is called Check-Disk and its duration can be several minutes. During this step, a message " checking the file
system of data partition in progress" is displayed on the screen. ³
Warning: errors on system partition
The user has to connect to device Web user interface, go to Maintenance > Tools menu, and click on the F ormat or
Repair button to solve the problem. ³
Warning: a firmware upgrade is pending
During this phase, no content is played on the device, do not switch OFF the device.
Error: write prob lem on the storage
For an unknown reason, your storage space isn' t usable any more. ³
Error. ¹
support@ qeedji.tech.
support@ qeedji.tech.
13
hour)
hour)