Assemble The Telma Brackets And Mounts; Install The Telma In The Chassis - Telma TL113005 Installation Manual

2.4 ASSEMBLE THE TELMA BRACKETS AND MOUNTS

•
Identify the driver's side of the Telma from the passenger side. To do so, orient the arrow of the red plate on the
Telma towards the axle with the red plate on the driver's side.
•
Identify the Telma brackets. The longer bracket TIB03123 is for the driver's side. The shorter passenger side
bracket is TIB03124.
•
Use four M14 bolts flat washers and Trep washers provided with the set of fasteners (JZ100280) to fasten the
Telma bracket onto each side of the unit. Tighten bolts to 65 lb.-ft (±10%).
•
Install the rubber mounts into the retarder brackets. Insert the male parts of the rubber mounts into the 1 5/8" holes
in the brackets from the bottom and the other half of the rubber mount on top. Place one 2 ¾" diameter 5/8" flat
washer on top of each mount.
•
Refer to the figure below for details.

2.5 INSTALL THE TELMA IN THE CHASSIS

•
Lift the Telma, equipped with its brackets and mounts, into place against the bottom of the chassis brackets.
•
Install the M16x1.5x100mm (4") bolts and spring washers down through the holes in the chassis brackets, mounts
and Telma brackets at each mount. Install a 2 ¾" diameter flat washer, a spring washer and M16 locknut at each
mount and tighten to 150 lb.-ft (±10%).
Page 6 of 30__________________________________________________________________________17feb12jh
Ford E-350/450 Cutaway Installation Manual with Telma Control Module (TRCM)
TL113005