Operation - Makita HR140D Instruction Manual

Optional accessory
NOTICE:
When the dust cup set is installed on the
then attach it to the optional grip base set.
Bolt Grip
NOTICE:
set due to the heat produced by small metal dust or
similar. Do not install or remove the dust cup set with
the drill bit installed in the tool. It may damage the
dust cup set and cause dust leak.
the protrusions on the tool barrel while widening it. Be
Spacer
Side grip
Dust cup
NOTE:
Dust cap
way and pull the drill bit out.
Bit Chuck cover
and pull it out.
Dust cup
NOTE:
Hook
Optional accessory
CAUTION:
hanging the tool with the hook.
CAUTION:
Never hook the tool at high location
Groove
housing on either side and then secure it with a screw.
Optional grip base set
It may damage the dust cup
Spring
Claws
Hook Screw

OPERATION

CAUTION:
CAUTION:
NOTE:
case, warm up the battery cartridge by using the
-
capability.
CAUTION:
hole break-through, when the hole becomes clogged
rods embedded in the concrete. Always use the side
Set the action mode changing knob to the
Do not apply more pressure when the hole becomes
clogged with chips or particles. Instead, run the tool at
By repeating this several times, the hole will be cleaned
out and normal drilling may be resumed.
NOTE: Eccentricity in the drill bit rotation may occur
CAUTION:
CAUTION:
CAUTION:
10 ENGLISH
Always make sure that the work-
-
symbol.
-