Safety Notices Specific To The Device - Parkside PMDS 100 A1 Operation And Safety Notes

General power tool safety warnings
the electronic device or the cable. Keep them
away from the area you are working in.
Keep the device in a safe place when
not in use! Electronic tools should be stored
in a dry, elevated or closed-off place, out of
the reach of children.
Do not overload your electronic device!
They work better and safer within the stated
performance range.
Use the appropriate electronic device!
Do not use a weak performing machine for dif-
ficult tasks. Do not use the electronic tool for any
other purpose than its intended use. For example,
do not use a hand-held circular saw for cutting
tree branches or logs.
Wear suitable clothing! Do not wear any
clothing which could be caught in moving parts.
Wear appropriate shoes when working outdoors.
Wear a hair net if you have long hair.
Use protective equipment!
Wear protective glasses. Use a
breathing mask when carrying out
work which produces dust.
Ensure that the dust extraction system
is attached appropriately! In the event
that a dust extraction and collection system are
available, ensure that these are properly installed
and that you use them correctly.
Do not use the cable for anything other
than its intended purpose! Do not unplug
from the socket by the cable. Protect the cable
from heat, oil and sharp edges.
Secure the work-piece properly! Use
clamps or a vice to secure the work piece. This
will secure it more safely than your hand.
Avoid putting your body in an unnatu-
ral position! Keep proper footing and balance
at all times.
Take care of your devices. Keep cutting de-
vices sharp and clean to be work more safely.
Pay attention to the notice concerning lubrication
and tool change. Check the connecting lead
of the electronic device regularly and have it
replaced by a recognised specialist where re-
quired. Check extension cables regularly and
replace them if they become damaged. Keep
handles dry, clean, and free from oil and grease.
16 GB
Remove the plug from the socket! When
the device is not in use, prior to maintenance and
when changing tools, e.g. saw blade, drill bits,
milling tools.
Do not leave tool keys connected! Be-
fore switching on check that keys and adjustment
tools have been removed.
Avoid unintended start-up! Ensure that
the switch is off when plugging in to the socket.
Use extension cords for outdoors! Only
use outside with suitable and appropriately
marked extension cables.
Pay attention! Pay attention to what you are
doing. Be sensible in your working. Do not use the
electronic device when you cannot concentrate.
Check the device for possible damage!
Before continuing use, the protectors or parts
with minor damage must be checked that they
are not compromised in their function and that
the device works properly.
Check that moving parts work properly and that
they are not stuck or damaged. All unit parts
must be correctly assembled and comply with
all guidelines in order to ensure correct and safe
operation of the device. Damaged protectors
and parts must be repaired or replaced by a
recognised specialist, providing no other infor-
mation is given in the instruction manual.
Damaged switches must be replaced by an
authorised dealer workshop.
Do not used devices where the switch cannot
be turned on or off.
ATTENTION! Using tools and accessories
could result in injury.
Only have your device repaired at a
specialist electrician! This electronic device
complies with all relevant safety regulations.
Repairs may only be carried out by a specialist
electrician and through using original replace-
ment parts, otherwise risk of accidents may result.
Safety notices specific
to the device
Do not use any damaged or misshaped disks
or brushes.