Hotpoint Ariston LTF 11S112 Operating Instructions Manual page 27

Refined salt and
rinse aid,
Only use products which have been specifically designed
for dishwashers. Do not use table salt or industrial salt.
Follow the instructions given on the packaging.
If you are using a multi-function product, we recommend
that you add salt in any case, especially if the water is hard
or very hard.
If you do not add salt or rinse aid, the LOW SALT
*
LOW RINSE AID indicator lights will remain lit.
Measuring out the refined salt
dishes and on the machine's functional components.
The salt dispenser is located in the lower part of the dishwasher
and should be filled:
*
is lit ;
*
on the cap of the salt dispenser is no
longer visible.
2. Only the first time you do this: fill the water
dispenser up to the edge.
fill the salt container right up to its edge
little water to leak out.
opening; rinse the cap under running water and then screw it on.
It is advisable to perform this procedure every time you add
salt to the container.
Make sure the cap is screwed on tightly, so that no detergent
damage the water softener beyond repair).
Whenever you need to add salt, we recommend carrying
out the procedure before the washing cycle is started.
Setting the water hardness
For perfect water softener operation, it is essential that the
adjustment be based on the water hardness in your house. Ask
your local water supplier for this information. The factory setting
is for medium water hardness.
P for 5 seconds until you hear a beep.
P to select the desired hardness level
hardness table).
*
Only available in selected models.
Water Hardness Table
level °dH
1 0 - 6
2 6 - 11
3 12 - 17
4 17 - 34
*
*
and 34 - 50
5
For values between 0°f and 10°f, we do not recommend the use of salt.
A setting of 5 may increase cycle duration.
Measuring out the rinse aid
should be filled:
*
;
is lit
becomes transparent.
and
1. Open the dispenser "D" by pressing and pulling up the tab
on the lid;
reference notch in the filling space - avoid spilling it. If this
happens, clean the spill immediately with a dry cloth.
NEVER pour the rinse aid directly into the tub.
Adjusting the amount of rinse aid
If you are not completely satisfied with the drying results, you
may want to adjust the quantity of rinse aid used.
P three times - a beep will be heard.
light flash.
P to select the level of rinse aid quantity to be
supplied.
supplied and the low rinse aid indicator light will not be lit if you
run out of it.
model. The factory setting is for a medium level.
Average autonomy
salt dispenser with 1
wash cycle per day
°fH mmol/l months
0 - 10 0 - 1 7 months
11 - 20 1.1 - 2 5 months
21 - 30 2.1 - 3 3 months
31 - 60 3.1 - 6 2 months
61 - 90 6.1 - 9 2/3 weeks
*
on the dispenser door "D"
EN
27