Hyundai H-ALMS2-07H/I Instruction Manual & Warranty Card page 14

14.
Electric air conditioner (split system)
NOTE
The FAN mode can not be used to control the temperature.
While in this mode, only steps 1Ў3 and 4 may be performed.
DRY Operation
1. Push the MODE button to select DRY.
2. Push the TEMP button to set the desired temperature from Ў Ў 17C to 30C.
3. Push the ON/OFF button, the OPERATION lamp lights and the air conditioner starts to operate
in DRY mode at LOW fan speed. Push the ON/OFF button again to stop this unit operation.
NOTE
Due to the difference of the set temperature of the unit and
the actual indoor temperature, the Air Conditioner when in
DRY mode will automatically operate many times without
running the COOL and FAN mode.
TIMER Operation
Push TIMER ON button to set the auto- on time and TIMER OFF
button to set the auto-off time.
1. To set the starting time.
1.1 Push the TIMER ON button, then the remote controller shows
TIMER ON , the last set time for the starting operation and the
signal "h" will be shown on the DIGITAL DISPLAY area. You are now ready to reset the time to
START the operation.
1.2 Push the TIMER ON button again to set desired unit start time.
1.3 After setting the TIMER ON ,there will be a one-half second
EN
delay before the remote controller transmits the signal to the air conditioner. Then, after approxi-
mately another 2 seconds, the signal "h" disappears and the set temperature will re-appear on
the digital display.
2. To set the stopping time.
2.1 Push the TIMER OFF button and the remote controller will show TIMER OFF, the last set time
for the stopping operation and the signal "h" will be shown on the DIGITAL DISPLAY area. You are
now ready to reset the time of the STOP operation.
2.2 Push the TIMER OFF button again to set the time you want to stop the operation.
2.3 After setting the TIMER OFF ,there will be a one-half second delay before the remote control-
ler transmits the signal to the air conditioner. Then, after approximately another 2 seconds, the
signal "h" disappears and the set temperature will re-appear on the digital display.