Channel Rack Graph Editor; Latch Edit; Quick Edit - Novation FLKEY 37 User Manual

Channel Rack Graph Editor

You can use pots one to eight to edit step parameters in Sequencer mode. They map to the eight
graph editor parameters from left to right (see table below for more details).In Sequencer mode the
pots default to the last selected pot mode; to enable Graph Editor you need to hold the step(s) you
want to change. The Channel Rack Graph Editor modes are below.
When you edit parameters, the graph editor shows in FL Studio. When you change a step's note
value, the graph editor window follows the note value you set.

Latch edit

Latch edit allows you to edit one, or multiple steps values. To enter Latch Edit mode, hold a step for
more than 1 second. The pads light in a graph editor parameter colour. This means you can release
steps before setting their parameters with a pot movement.
Press any step to add or remove it from the selection of latched steps. Any parameter change affects
all selected steps.
To exit latch edit mode, press the pulsing Channel Rack ▼ button.

Quick edit

Hold a step and move a pot within a second to enter quick edit mode. Press and hold a step pad and
move one of the eight pots to control the parameters in the graph editor. Parameter changes affect
any step held in quick edit mode.
The moment you move a pot, the graph editor appears in FL Studio and disappears when you release
the step.
To exit quick edit mode release all held steps.
To edit steps with more parameters, hold the step on the pads and then turn the pot.
Pot/Knob Graph Function
Pot 1
Note Pitch
Pot 2
Velocity
Pot 3
Release Velocity
Pot 4
Fine Pitch
Pot 5
Panning
Pot 6
Mod X
Pot 7
Mod Y
Pot 8
Shift
25