Advertisement
4. Slide the lower blowpipe over the upper blowpipe.
5. Rotate the lower blowpipe clockwise until a click indicates that the lower blowpipe is snapped
and secured onto the upper blowpipe.
6. To dismantle the pipes, turn the screw counter-clockwise (do not remove the screw nuts); loosen
the pipes and remove them.
Note: The lower and upper blower tubes are correctly installed when the arrows on both tubes are
exactly aligned.
Assembling the high-speed air nozzle
Attach the high-speed air nozzle if higher airflow speed is desired.
1.
Align the slots on the nozzle with the tabs on the lower blowpipe.
№
Name
1
High-speed nozzle
2
Notch
2. Slide the nozzle onto the lower blowpipe.
3. Turn the nozzle to the right until it clicks firmly into place on the lower blowpipe.
4. Each section of the pipe was then secured with a screw.
Assembling the collection bag
1.
Unzip the collection bag and insert the connecting pipe.
2. Push the narrow end of the connecting tube through the small opening in the collection bag.
№
Name
1
Adjusting spring
2
Narrow opening
Note: Make sure that the edge of the narrow opening is flush with the widening connecting tube and
that the notch on the connecting tube points downwards.
3. Close the zipper on the collection bag. The zipper must be completely closed.
4. Remove the blower tube from the device.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
№
Name
3
Flap
4
Lower blowpipe
№
Name
3
Zipper
4
Connection tube
Item 61955
Page 8
12
2021-1
Advertisement
