Allowing Drives To Be Used As Destination/Target - Logicube ZXi-10G User Manual

10. A confirmation screen will appear. Make sure that the "Target Device" is set to the correct
drive letter. If it is the correct drive letter, click Yes to continue. If it is showing the wrong drive
letter, click No. This will take you back to the previous screen where you can select the correct
drive letter (back to step 9).
11. The USB flash drive is now being prepared and the progress bar should be advancing.
12. When it is finished, a prompt should appear stating Write Successful. Click the OK button to
continue. Close the Win32 Disk Imager window. The USB flash drive is now ready to be used.

9.3 Allowing drives to be used as Destination/Target

By default, the USB Boot Client allows drives to be used only as Master drives. Additional steps are
required to allow drives to be used as Destination/Target drives.
1. With the USB Boot Client connected to a Windows computer, open File Explorer or Windows
Explorer.
For these steps, it is helpful to
set File Explorer or Windows
Explorer to show file extensions.
2. Browse to the ISCS_LIVE flash drive that was just created.
Logicube ZXi-10G™ User's Manual
USB BOOT CLIENT
93