Arturia FARFISA V User Manual page 33

3.4.2.2. Reserved MIDI CC numbers
Certain MIDI Continuous Controller (MIDI CC) numbers are reserved and cannot be
reassigned to other controls. These are:
• Ctrl All Notes Off (CC #123)
• PitchBend
• AfterTouch
All other MIDI CC numbers may be used to control any assignable parameter in Farfisa V.
The Knee Lever is a special case: a switch in the Advanced panel lets it be controlled by a
MIDI CC, PitchBend, or AfterTouch.
3.4.2.3. MIDI Parameter Menu
Control-clicking or right-clicking on any item in the list of assigned parameters brings up a
pop-up menu with the following options, which can be different for each parameter.
Absolute: The assigned parameter in Farfisa V tracks the literal value your
•
physical controller is sending out.
Relative: The assigned parameter in Farfisa V will go up or down starting from its
•
current value in response to physical controller movements. This is often useful
when using endless 360-degree encoders that don't have physical motion limits.
Delete: Removes the assignment and turns the corresponding onscreen control
•
purple again (when the display is in Learn mode).
Change Parameter: Brings up a large sub-menu of every assignable parameter
•
in Farfisa V. This lets you change the assignment of the current CC/physical
control manually and is useful when you know exactly the destination you're
looking for.

This same sub-menu will appear when you click + Add Control at the bottom of the window.
Arturia - User Manual Farfisa V - User Interface 28