Removing And Fitting The Door Panels - Siemens iQ700 Instruction Manual

Removing and fitting the door panels

To facilitate cleaning, you can remove the glass panels
from the appliance door.
:
Warning
Risk of injury!
Scratched glass in the appliance door may develop
■
into a crack. Do not use a glass scraper, sharp or
abrasive cleaning aids or detergents.
The hinges on the appliance door move when
Risk of injury!
■
opening and closing the door, and you may be
trapped. Keep your hands away from the hinges.
Components inside the appliance door may have
Risk of injury!
■
sharp edges. Wear protective gloves.
Removing the door panels from the appliance
Open the appliance door slightly.
1.
Press on the right and left side of the cover (fig.
2.
Remove the cover (fig.
3.
Undo and remove the screws on the left and right of
4.
the appliance door (fig.
Before closing the door again, trap a tea towel that
5.
has been folded several times in the door (fig.
Pull out the front panel upwards and lay it on a flat
surface with the door handle facing downwards.
Clean the panels with glass cleaner and a soft cloth.
).
"
).
#
:
Warning – Risk of serious damage to health!
If the screws are loosened, the safety of the appliance
can no longer be guaranteed. Microwave energy may
escape. Never loosen the screws.
Do not unscrew the four black screws on the frame (fig.
).
%
).
!
Fitting the door panels on the appliance
Insert the front panel downwards into the retainers
1.
(fig. ).
!
Close the front panel until both upper hooks are
2.
opposite the opening (fig.
).
$
Press the front panel down until it clicks audibly into
3.
place (fig.
Open the appliance door again slightly and remove
4.
the tea towel.
Screw both screws back in on the left and right.
5.
Put the cover back in place and press on it until it
6.
clicks audibly into place (fig.
Close the appliance door.
7.
Caution!
Do not use the cooking compartment again until the
panels have been correctly fitted.
Appliance door
).
"
)
#
).
$
en
29