Starting Or Interrupting Operation; Selecting An Operating Mode; Setting The Type Of Heating And Temperature; Rapid Heat Up - Siemens iQ700 Instruction Manual

Operating the appliance
en

Starting or interrupting operation

To start operation or to interrupt an operation which has
started running, press the Start/Stop button. The
cooling fan may continue to run after an operation is
interrupted.
Press the On/Off button to delete all settings.
If you open the cooking compartment door during
operation, operation is interrupted. Close the cooking
compartment door to continue operation.

Selecting an operating mode

When you select an operating mode, the appliance
must be switched on.
Press the menu button.
1.
The operating modes menu opens.
Touch the required operating mode.
2.
Depending on the operating mode, different options
are available.
Use the rotary selector to change the selection.
3.
Depending on the selection, change further settings.
Use the start/stop button to start.
4.
The elapsed time appears in the display. The
settings and progress line can be seen.

Setting the type of heating and temperature

After the appliance is switched on, the set suggested
type of heating appears with the temperature. You can
start this setting immediately with the start/stop button.
If you want to set another type of heating, proceed as
follows.
For other settings, you can change the values as
follows:
Example in the picture: Top/bottom heating at 180 °C.
Set the type of heating using the rotary selector.
1.
Touch the suggested temperature.
2.
Use the rotary selector to change the temperature.
3.
16
Use the start/stop button to start.
4.
The set type of heating and the temperature are shown
in the display.

Rapid heat up

You can use the button to heat up the cooking
c
compartment particularly quickly.
The rapid heat up function is not possible for all types of
heating.
Suitable types of heating:
4D hot air
:
Top/bottom heating
%
To ensure an even cooking result, do not place your
food and the accessory in the cooking compartment
until rapid heating is complete.
Making settings
Ensure you have selected a suitable type of heating.
The temperature must be set to above 100 °C,
otherwise the rapid heating function cannot be started.
Set the type of heating and temperature.
1.
Press the button.
c
2.
The symbol appears on the left next to the
c
temperature. The temperature indicator starts to fill in.
When rapid heating is complete, a signal sounds. The
symbol goes out. Place your dish in the cooking
c
compartment.
Notes
If a cooking time has been set, this runs
■
independently of rapid heating and counts down
immediately when the operation is started.
You can use the button to check the current
l
■
cooking compartment temperature during rapid
heating.
Cancelling
Press the c button. The
the display.
c symbol disappears from