Table of Contents
Advertisement
TRACKMASTER
Smart Power Supply Error Code 1 Flow Chart 1J "Bad Speed Calibration"
1J
Is the Red LED D13
flashing 1 time with a
4 second pause on the
Smart Power Supply
FG0495?
Yes
Verify treadmill power switch
is in the off (O) position.
Perform Test Plug Procedure
to test elevation & treadmill
running belt speed.
Did treadmill
cycle according to
Test Plug
Procedure?
Yes
Connect Stress System &
perform test.
Did treadmill
respond to Test
Procedure?
Yes
Return Treadmill
to service.
317-160-406 Rev 4
May 2021
Ch. 9
Is the Red LED D13
No
flashing on the
Smart Power Supply
Using the Full Vision Treadmill
PS New Cal software connect
communication thru RS232 or
USB.
Select
treadmill will start out slow and
increase speed to maximum.
Turn the treadmill power switch
OFF (O) for 10 seconds then
No
turn the power switch ON (-).
No
TMX428 TMX428CP & TMX58 Service Manual
Yes
1I
No
FG0495?
the
Is the Red LED D13
flashing on the
Smart Power Supply
FG0495?
No
Treadmill should
be operational.
Troubleshooting
Treadmill should
be operational.
Yes
1I
79
Advertisement
Table of Contents
