Tesla MODEL S 2012 Owner's Manual page 197

1. Touch Controls > Suspension on the touchscreen.
2. Press the brake pedal, then touch Very High to
maximize height.
3. Touch Controls > Service > Jack Mode.
NOTE: Jack Mode cancels when driving speed exceeds 4
mph (7 kph).
WARNING: Failure to activate Jack Mode on a
vehicle equipped with the air suspension system
can result in the vehicle becoming loose during
transport, which may cause significant damage.
Activate Transport Mode
Transport Mode keeps the parking brake disengaged
while winching Model S onto a flatbed truck. When
active, Transport Mode displays a message indicating
that the vehicle will remain free-rolling. The following are
required to enable Transport Mode:
• Low voltage power is required. You are unable to use
the touchscreen to activate Transport Mode if
Model S has no power.
• Model S must detect a key fob. Transport Mode is
available only when a key fob is detected.
To activate Transport Mode:
1. Ensure the vehicle is in Park.
2. Chock the tires or otherwise ensure Model S is
secure.
3. Press and hold the brake pedal, then on the
touchscreen, touch Controls > Service > Towing. The
touchscreen displays a message reminding you how
to properly transport Model S.
4. Press and hold the Transport Mode button until it
turns blue. Model S is now free-rolling and can slowly
be rolled (no faster than walking speed) or winched.
To cancel Transport Mode, shift Model S into Park.
NOTE: If Model S loses low voltage power after
Transport Mode is enabled, Transport Mode cancels.
CAUTION: If the electrical system is not working,
and you therefore cannot use the touchscreen to
activate Transport Mode, use self-loading dollies or
tire skates. Before doing so, always check the
manufacturer's specifications and recommended
loading capacity.
Pull onto the Flatbed Truck - With
Tow Eye
1. Locate the tow eye.
Roadside Assistance
Instructions for Transporters
2. Remove the tow eye cover by inserting a small flat
screwdriver into the slot located along the top of the
cover, then prying gently to release the cover from
the top snap.
NOTE: Keep the tow eye cover in a safe place so you
can replace it when towing is complete.
3. Fully insert the tow eye into the opening, then turn it
counter-clockwise until securely fastened.
4. Attach the winch cable to the tow eye.
CAUTION: Before pulling, make sure the tow
eye is securely fastened.
5. Activate Transport Mode by touching Controls >
Service > Towing.
6. Pull Model S slowly onto the flatbed truck.
195