Table of Contents
Advertisement
PROGRAM
Family Code Selection
Organizer Control
1st Organization
2nd Organization
Include/Exclude Control
FACTORY DEFAULT
The Data Organizer is used to edit the scanned raw data prior to transmitting the data to the host computers or terminals. It allows you to select desired bar code
symbologies for organizer control, and provides a maximum of two identified positions to send the data before or after. It also allows you to control the transmitted
data including or excluding the data of the identified position. Please refer to the application example on the next page for details.
While the Data Organizer is enabled, it arranges only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID, or
Record Suffix.
Please refer to the next page for information about the "Bar Code Selection" and "Position Calculation" of Data Organizer.
To determine the hex value for the "Character," refer to the HEX/ASCII Table listed on page A-6.
Refer to page 3-12 for 2-digit symbology option code.
Programming the Scanner
Condensed Data Editor
♦ Data Organizer Settings ♦
Parameter Selection
Disable
Select one bar code symbology
Select all bar code symbologies
Disable
Enable
2-digits identified character position;
Transmit data before/after this position
Disable
Enable
2-digits identified position;
Transmit data before/after this position
Transmitted data excluding the data of identified position
Transmitted data including the data of identified position
3-36
END(Exit)
Option Code
2nd Option Code
FIN
automatic termination
(2 digits)
00
automatic termination
FIN
Direction :
(2-digit decimal
0 (Before)
value)
1 (After)
position
FIN
Direction :
(2-digit decimal
0 (Before)
value)
1 (After)
position
0
1
Advertisement
Table of Contents
