Hand Held Products Valueteam 3060 User Manual page 13

RS-232 Interface Installation
Verify the RS-232 port (COM1 or COM2) available on your
computer system.
Plug the RJ45 phone plug of the main cable into the RS-232
cable adapter.
Plug the 9-pin or 25-pin D-sub connector of the cable converter
into the desired serial port on your system.
A
ttach the power outlet plug of the optional AC power adapter to
the side power jack of the D-sub connector. You will hear the
power-on beep twice to signal that the scanner is ready for bar
code reading. Scan the " RS-232 Serial Interface " bar code to
configure the scanner to perform the RS-232 serial interface
operation.
RS-232 Serial Interface
Terminal Interfaces
Scanning the RS-232 interface bar code above configures the
scanner's serial parameters to 9600 Baud, 8 data bits, no parity,
and 1 stop bit, no handshaking.
Please note that the RS-232 settings of the host system must
match the scanner's RS-232 settings.
If you are in the Windows
Terminal " to test.
PIN-1: VCC (5V)
PIN-2: TD
PIN-3: RD
PIN-4: NC
PIN-5: GND
PIN-6: NC
PIN-7: CTS
PIN-8: RTS
PIN-9: VCC (5V)
9 Pin D-sub RS-232 Female Connector
PIN-2: RD
PIN-3: TD
PIN-4: CTS
PIN-5: RTS
PIN-6: NC
PIN-7: GND
PIN-16: VCC (5V)
PIN-25: VCC (5V)
25 Pin D-sub RS-232 Female Connector
2-3
® environment, you may use the " Hyper
Standard RS-232 Pinouts
-
(
+
(
-
( )
+
( )
)
)