Advertisement
3
WORK
3.4
Installing the front fender
3.5
Installing the start number plate
3.6
Opening the filler cap
Danger
Fire hazard Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See the notes on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Avoid contact between fuel and skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse immedi-
ately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed, con-
tact a doctor immediately. Change clothing that has come into contact with fuel. Store fuel in a suitable canister according
to regulations and keep it out of the reach of children.
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
–
Do not allow fuel to get into the ground water, the ground, or the sewage system.
–
Pull the front wheel brake and push down hard on the fork several times to align
the fork legs.
–
Tighten screws
Guideline
Screw, fork stub
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Ensure that the spacers are mounted in the fender.
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
Info
Make sure the holding lugs engage in the start number plate.
L00040-10
–
Position the start number plate. Mount and tighten screw
Guideline
Remaining screws, chassis
Info
Make sure that the holding lugs engage in the fender.
–
Position the brake line and clamp. Mount and tighten screw
L00049-10
.
3
M8
15 Nm
(11.1 lbf ft)
p. 6)
.
1
M6
10 Nm (7.4 lbf ft)
.
1
M6
10 Nm (7.4 lbf ft)
.
2
7
Advertisement
