Advertisement
SET‑UP
Unpacking and setting up the vehicle
2.1
–
Open the box.
Info
To avoid damaging the vehicle during assembly, do not remove the protec-
tive plastic from a part until just before mounting it and leave the plastic
sheeting on the vehicle until work is completed.
–
Remove the front wheel, fender, hand protectors, and enclosed package from the
box.
–
Remove the separate enclosure and unpack it. Check that the scope of delivery is
700529-01
complete on the basis of the enclosed packing list.
–
Lift the vehicle out of the box with the help of another person.
–
Jack up the motorcycle. (
–
Check the vehicle for transport damage.
–
Remove screw
–
Loosen screws
–
Remove the wheel spindle.
–
Install the front wheel.
–
Remove the protective plastic from the handlebar.
700530-01
–
Position the handlebar with handlebar clamps
–
Mount and tighten the screws.
Guideline
Screw, handlebar clamp
–
Check the handlebar position.
»
If the handlebar position is not adjusted as the customer requires:
–
Adjust handlebar position.
700531-01
–
Install the front fender. (
–
Check the wiring harness, throttle cables and brake line for free movement and cor-
rect routing.
–
Check that all controls on the handlebar are in the correct location and seated
firmly.
–
Mount the footrests with the springs and bolts. Secure the bolts using the washers
and pins.
Plier for footrest spring (58429083000)
–
Fill up with fuel. (
–
Print out the current PDI form found on KTM DEALER.NET and perform the delivery
inspection.
800042-10
p. 4)
.
.
x
(
p. 4)
M8
(
p. 5)
x
p. 5)
p. 6)
.
20 Nm
(14.8 lbf ft)
3
Advertisement
