Reassembling The Bowl - Univex UPASTA Operating And Maintenance Manual

7.3.3 - Reassembling the bowl

Follow these operations to reassemble the bowl correctly:
REASSEMBLING THE BOWL
After having centred the bowl correctly REF. 15
with the 9 pins REF. 16, use two hands to push it
into position until it is fully in contact with the
casing.
REASSEMBLING THE BOWL FRONT PANEL
To reassemble the front panel REF. 14 after
having centred it correctly with the 9 pins REF. 16,
hold it still with one hand and push it towards the
bowl until it stops REF. 15; then fasten it by
tightening the 8 knobs REF. 13.
REASSEMBLING THE LID
To reassemble the lid REF. 2, insert the knob
REF. 12 in the 2 holes on the side flaps of the lid.
Position the lid on axis with the threaded hole
REF. A on the casing. Tighten the knob REF. 12
until the lid is completely fastened.
REASSEMBLING THE COUPLING
To reassemble the coupling REF. 11, align it to
the 4 M8 bars REF. 17, then push it until it stops
against the front panel REF. 14 and fasten the
whole by tightening the 4 bolts REF. 10 while
holding the coupling with one hand and making
sure that the parts are correctly aligned.
Fig. 7.3.5
Fig. 7.3.6
Fig. 7.3.7
19
16
15
2
A
14
12
13
14
17
10
11