Controls And Indicators; List Of Controls And Indicators - Univex UPASTA Operating And Maintenance Manual

3 - Controls and indicators

3.1 - List of controls and indicators

4 5
3
1 2
Fig. 3.1.1
1 - Switch positioned to kneading mode (FWD)
This position sets the machine to kneading mode; the screw rotates clockwise and
conveys the product to the bottom of the bowl.
2 - Switch positioned to extruding mode (REV)
This position sets the machine to extruding mode; the screw rotates anticlockwise
and conveys the product towards the extruder.
The screw applies pressure to the dough towards the extruder and the pasta starts
drawing.
3 - Switch positioned to motor switch off mode (OFF)
In this position, the motor switches off and the machine stops.
WARNING: The electricity line is still active.
N.B: To switch from kneading mode to extruding mode, switch the machine off,
change the mode selection and turn the machine back on.
4 - "ON" button
This button must be pressed only after having set
the selector switch to extruding or kneading mode.
If the switch is set to OFF the machine will not start.
5 - Stop button
Stop the machine completely by removing the power supply.
WARNING!
the machine is equipped with a forced ventilation system (fan) controlled by a
bimetallic switch connected to the motor. When the motor reaches 60 C, the fan
starts autonomously and continues operating until the motor temperature drops
down to 40°C.
13