Table of Contents
Advertisement
7 - Maintenance
7.1 - Safety instructions
WARNING!
Maintenance and cleaning must always be carried out with the machine at a
standstill and disconnected from the mains power supply.
Always keep the maintenance zone clean and dry.
Do not allow unauthorised persons to intervene on the machine.
Any replacements of parts and accessory tools must be performed using original
spare parts at authorised service centres, or directly by the manufacturer.
7.2 - Lubrication
The machine does not require any lubrication.
7.3 - Cleaning the machine
WARNING! Disconnect the machine from the mains power supply before cleaning
it. Do not clean the machine using a water jet. Only use non-toxic detergents
specifically formulated for cleaning components used with foodstuffs.
7.3.1 - Removing the accessory tools
At the end of each processing cycle,
remove the accessory tools to clean
the machine effectively
Removing the mixer blade
1. Put the blade "1" in the position
shown in Fig. 7.2.1.
2. Raise the lever "2" and remove the
bar "3".
3. Remove the blade "1" by sliding it
upwards.
WARNING! If the blade is not lying in
the position shown in Fig. 7.2.1, it
cannot be removed.
Removing the worm
1 - unscrew the ring nut 4
2 - remove the die 5
3 - remove the worm 6
WARNING!
Make sure that you clean the drive pins thoroughly after
use
in order to ensure correct coupling
of the blade and screw (Fig. 7.2.2)
6
1
Fig. 7.2.1
17
2
3
5
4
Fig. 7.2.2
Advertisement
Table of Contents
