Table of Contents
Advertisement
TASKS
Installing the rear fender
3.4
Recharging the battery
3.5
Warning
Risk of injury Battery acid and battery gases cause serious cauterization.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a doctor.
Warning
Environmental hazard Components and battery acid are a danger to the environment.
–
Do not dispose of batteries in normal household waste. Take defective or used batteries to a battery recycling operator.
Warning
Environmental hazard Problem materials cause environmental damage.
–
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
–
Raise the rear of the air filter box lid
press on the carburetor connection boot to kink it at that location. This prevents the
carburetor connection boot from disconnecting from the carburetor.
–
Raise the fender
200148-10
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Raise the rear of the air filter box lid
press on the carburetor connection boot to kink it at that location. This prevents the
carburetor connection boot from disconnecting from the carburetor.
–
Position the front fender
–
Fix the air filter box lid in the fender.
200148-11
–
Fit and tighten screws
Specification
Remaining screws, chassis
–
Mount the seat (
200149-11
. At the same time, use your other hand to
2
at the rear and remove it.
3
. At the same time, use your other hand to
1
.
2
with collar sleeves.
3
M6
P. 4)
5
10 Nm (7.4 lbf ft)
Advertisement
Table of Contents
