Controls And Settings - Frigidaire FFCL2542AW Use & Care Manual

8

CONTROLS AND SETTINGS

Temperature Control*
D
C
B
A
*This graphic is for reference only. The
configuration varies by model.
A. Temperature Setting Press Temp
to display the freezer temperature.
Press Temp continuously
to cycle through the temperature
setting as follows:
-12°C  -13°C  -14°C...
°C
-18°C... -22°C -23°C -24°C
10°F 8°F 7°F... 0°F...
°F
-9°F-10°F-11°F
B. Freeze Boost Press Freeze Boost to
illuminate
display -24°C/-11°F. Press Freeze
Boost to exit.
E
. The temperature will
C. Temperature Display After the
freezer powers on, the temperature
display will stay lit for 3 seconds,
and then the freezer will enter
normal operation, and display the
set temperature if there is no power
failure. If there is a power failure, the
display will show an error code.
The temperature display will go in
sleep mode 30 seconds after you
confirm the temperature. When
the temperature display shows ON,
press Temp and Freeze Boost for 5
seconds to enter sleep mode. When
the temperature display shows OF,
press Temp and Freeze Boost for 5
seconds to exit sleep mode.
D. High Temp The temperature display
will show High Temp if the freezer
elevates above the set temperature.
E. °C/°F Press Temp for 3 seconds
to convert the temperature setting
from °C to °F.
Lock/Unlock
To lock the temperature setting, press
and hold Freeze Boost for 3 seconds.
The display will blink once, and the
temperature will remain set. The display
will blink twice to remind you it is locked
if you try to change the setting.
To unlock the temperature setting, press
and hold Freeze Boost for 3 seconds.
The display will blink once, and the
temperature setting can be changed.
Power Failure
After a power failure, when power is
restored, all settings except super freeze
will resume operation.
Failure Code
If you see the failure code below on the
display, call your service provider:
E2
Temperature sensor failure