Frigidaire FFCL2542AW Use & Care Manual page 6

6
INSTALLATION
To install the casters:
1. Move appliance to a work area that
provides sufficient clearance on all
4 sides to allow easy handling and
access to the appliance.
2. Cover the floor area behind the ap-
pliance with a protective material to
prevent damage while it is resting on
its back during the caster installation.
CAUTION
Two or more people are required to
rotate and tilt the appliance on its back,
allowing accessibility to all sides.
3. Remove the adjustable leveling legs
already installed on the appliance by
unscrewing counterclockwise, as they
are not required when using casters.
4. Remove casters and screws from
the caster kit. The Part A casters
are installed on the right front and
rear compressor side of the appli-
ance. The Part B casters are installed
on the left front and rear of the
appliance (with brake lever facing
outside). Align the caster holes with
the corresponding screw holes in the
mounting locations. See Figure 1.
Front
Part A
Part B
Bottom View
of Freezer
Left Side Middle
Part B
Part A
Rear
5. After casters are installed, with the
6. Wait a minimum of 2 hours before
7.
Casters with brakes are to stop chest
freezer movement on level ground only.
They are not intended to prevent move-
ment on an uneven or sloping floor.
Part A
Right Side
Part A
Figure 1
help of an assistant, carefully lift and
rotate the appliance to its upright
position. Move the appliance to the
desired location, and engage brakes
on the 2 left casters.
connecting the appliance to an AC
power source. Avoid using a Ground
Fault Circuit Interrupter (GFCI)
outlet. Do not use an extension cord.
Load the appliance after the desired
operating temperature is reached.
WARNING