Controls And Settings (Units With Temperature Control Inside) - Frigidaire FFFU20F2VW Use & Care Manual

(UNITS WITH TEMPERATURE CONTROL INSIDE)
Cool Down Period
To ensure safe food storage, allow the ap-
pliance to operate with the door closed for
at least 8 hours before loading it with food.
Appliance Control

NOTE
When first turning appliance on, adjust
control to Recommended. After 24
hours, adjust the controls as needed.
IMPORTANT
Adjusting the appliance temperature
control to OFF turns off the compressor
and prevents the appliance from cool-
ing, but does not disconnect the power
to the light bulb and other electrical
components. To turn off power to your
appliance, you must unplug the power
cord from the wall outlet.
Appliance Control
Temperature Adjustment
Adjust temperature gradually: adjust the
knob in small increments, allowing the
temperature to stabilize.
• For colder temperatures, adjust the
knob towards Coldest.
• For warmer temperatures, adjust the
knob towards Cold.
CONTROLS AND SETTINGS
Alarms
High Temp Alert
If the temperature increases above
freezing your food, the LED light at the
bottom of the cabinet will flash and the
alarm will sound. The alarm can be reset
by opening and then closing the door.
The LED will continue to flash until the
cabinet temperature is below 23°F (-5°C).
If the internal temperature remains high
for 15 minute and there has not been a
power failure, call Frigidaire at 1-800-374-
4432 for assistance.
Door Ajar Alert
This alert will sound to alert you that
the door has been open for 5 minutes or
more. The audible alert will sound until
the door is closed.
Power On Light
The green LED Power On light indicates
that the appliance is properly connected
to electrical power. The light glows
even when the temperature control is
turned to OFF. If the light goes out,
refer to Appliance does not run in
TROUBLESHOOTING.
17