Grizzly H8238 Instructions

For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
To reduce risk of serious burns, electrocu-
tion or death when installing this switch:
• Only use this switch to replace an existing
machine switch that has the same physi-
cal configuration and equivalent electrical
specifications/ratings.
• Installation must only be performed by an
electrician or qualified service personnel,
and all applicable electrical codes must
be adhered to.
• Turn off and completely disconnect all
power sources to the machine before
installing the switch.
• Do not use this switch in wet or damp
locations, or near explosive fumes or
flammable liquids. It is not sealed or rated
for these environments.
• Make sure there is a verified machine
ground on the circuit this switch is
installed.
WaRNINg: NO pORTION OF THIS INSTRUCTION SHEET May bE REpRODUCED IN aNy SHapE
OR FORM WITHOUT THE WRITTEN appROVaL OF gRIzzLy INDUSTRIaL, INC.
Copyright © ApriL, 2011 By grizzLy industriAL, inC.
#ts13932 printed in ChinA
MODEL H8238
110/220V ON/OFF SWITCH
INSTRUCTIONS
Figure 1. h8238 on/oFF switch.
Introduction
the Model h8238 features a recessed stArt
button that can be disabled with a padlock. the
switch assembly can be mounted on a standard
electrical box.

Specifications

rated Voltage ....................................... 120/240V
rated horsepower/Current at 120V ....... 2hp/35A
rated horsepower/Current at 240V ...... 3hp/20A
phase ........................................................ single
padlock shaft size .........................................
padlock
hole
⁄ "
3
16