Sanding Belt Replacement - Grizzly H3140 Owner's Manual

Sanding Belt
Replacement
some sanding belts are designed to sand in only
one direction and will have directional arrows on
the back of the belt. the Model h3140 is designed
so that the sanding belt travels downward at the
sanding table.
To change the sanding belt:
1. disConneCt sander FroM poWer!
2.
unscrew the knob from the sanding belt
cover (figure 13) and remove the cover from
the sander.
Knob
figure 13. sanding belt cover.
-18-
sanding belt
Cover
3.
press firmly against the tracking adjustment
knob to remove the tension from the sanding
belt.
4. roll the old sanding belt off the three pulleys,
and roll the new belt back on, making sure
the directional arrows on the back of the belt
point downward at the table (figure 14).
figure 14. Replacing sanding belt.
5.
Make sure the sanding belt is positioned in
the center of all three pulleys.
6.
replace and secure the sanding belt cover.
7.
Check and the adjust the sanding belt track-
ing, as instructed on page 17.
Model h3140 (Mfg. after 6/02)
sanding
belt
direction