Introduction; Legal Notice; Illustrations; Symbols - PANHANS 334|20 Operating Manual

1 Introduction

The purpose of this operating manual is to acquaint the
user with the machine and enable him to use it to the
full extent of its intended capabilities. Additionally it
contains important information to operate the machine
safely, properly and economically.
Observance of the manual helps to avoid hazards, re-
duce repair costs and downtimes and increase the reli-
ability and service life of the machine.
Furthermore, this operating manual serves to supple-
ment instructions based on national regulations for
accident prevention and environmental protection.
This operating manual must always be available at the place of use of the machine. It must
be read and followed by every person who is assigned to work on the machine, e.g.
• during operation, including set-up, troubleshooting in the work process, removal of pro-
duction waste and maintenance,
• during maintenance (servicing, inspection, repair)
• and/or during transport.
Apart from the operating manual and the legally binding accident prevention provisions applicable in the coun-
try and place of use, the recognized technical regulations for safe and proper work must also be observed.
1.1

Legal Notice

All contents of these operating instructions are subject to the rights of use and copyright of Hokubema Maschi-
nenbau GmbH. Any reproduction, modification, further use and publication in other electronic or printed me-
dia, as well as their online publication, requires the prior written consent of Hokubema Maschinenbau GmbH.
1.2

Illustrations

All photos, figures and graphics contained in this document are for illustration and better understanding only
and may differ from the current state of the product.
2

Symbols

2.1

General Symbols

Symbol Meaning

Indicates passages within this operating manual that must be particularly observed in order to
prevent malfunctions or damage to the machine.

Refers to chapters, sections, or figures within this document.

Refers to an external document or a third-party source.
BA_PH_335-20_EN_07-22.docx
Figure 1: Surface planer & jointer 335|20
6