Adjusting The Outfeed Table; Figure 18: Outfeed Table Handwheel - PANHANS 334|20 Operating Manual

10.3 Adjusting the Outfeed Table

H

Figure 18: Outfeed table handwheel


In the standard model, the delivery table is factory-set exactly to the flying circle of the cutter.
It should only be adjusted if the knives have been set differently (for example, after sharpening)
BA_PH_335-20_EN_07-22.docx
When changing the standard TERSA knives, readjustment of the
outfeed table is not necessary!
Only if other cutter types are used and these are re-sharpened, it
may be necessary to adjust the outfeed table via handwheel (H).
Clockwise ↻
Direction +
Counterclockwise ↺
 upwards 
Direction ̶
 downwards 
30