Installation And Connection; Check Delivery Conditions; Transport; Installing The Machine - PANHANS 334|20 Operating Manual

7 Installation and Connection

7.1

Check Delivery Conditions

Check the consignment for completeness and possible transport damage. In case of transport damage, please
keep the packaging and inform the shipping company and the manufacturer immediately! Later complaints
cannot be accepted.
7.2

Transport

The machine is delivered on a transport pallet and is bolted
to the bottom of the pallet. The centre of gravity of the
machine is approximately in the middle of the pallet.
• Drive a pallet truck between these timbers, lift the
pallet only a few centimetres and move it to the im-
mediate vicinity of the installation site.
• Dismantle the bolted fastening of the machine on
the transport pallet.
• Move a forklift truck under the machine from the front
and lift it a few centimetres.
• Lifting the machine off the pallet with the forklift truck.
• Move a lift truck from the front between the machine, lift it only a few centimetres and move it to the
final installation location.
Pay attention to the existing danger of tipping over during transport!
7.3

Installing the Machine

• A foundation is not required. The floor must have a load-bearing
capacity corresponding to the weight of the machine.
• Before placing the machine on the ground, fit the four supplied
underlays (U) under the feet. One screw with 3 corresponding
SW17 nuts is attached to each machine base. The machine must
be properly aligned with a 0.1 mm/1 m machine spirit level. To
do this, loosen the lock nut (K) and adjust the height with nut
(E). Then tighten the lock nut (K) again.
• There is a 13 mm diameter hole (B) on each of the four machine
feet. If necessary, the machine can be bolted to the floor via
these holes.
• The bare parts of the machine are greased to protect them from
corrosion. Carefully degrease the parts protected against rust
with petroleum or benzine.
Be aware of possible crushing hazards when placing the machine (from the pallet to the
floor) by means of a forklift truck or overhead crane. Pay particular attention to your
hands and feet and wear safety shoes and protective gloves as a precaution.
Danger to life when using a forklift truck! Keep a sufficient distance from the forklift truck
and watch its speed. Vehicles with combustion engines also produce toxic exhaust gases.
Wear a breathing mask if necessary.
BA_PH_335-20_EN_07-22.docx

Figure 7: Transportation

K
E

Figure 8: Adjustable underlay

B
U
22