Table of Contents
Advertisement
10 Machine Operation
All adjustment and operation work is only permitted when the cutter block is stopped!
10.1 Electrical Chip Removal Adjustment
U
The chip removal thickness is set with the keys (U) and (D).
•
Pressing button (D) lowers the infeed table
The chip thickness increases.
•
Pressing button (U) raises the infeed table.
D
The chip thickness decreases.
Figure 16:
Chip removal
10.2 Hollow and Pointed Joint Adjustment
With the adjusting screw (S) under the outfeed table, the outfeed table can be inclined to the infeed table so
that a hollow or a pointed joint is obtained.
Hohl- und Spitzfuge
Einstellung
Diese Ei nstellung nur bei eingeschalteter
Steuerung vornehmen!
S
Figure 17: Hollow / pointed joint adjustment
Important: Hollow and pointed joint adjustment only when the control unit is switched on.
10.2.1 Calibrate Hollow and Pointed Joint on the Digital Indicator
If the adjusting screw (S) for the hollow and pointed joint adjustment has been adjusted whilst the digital dis-
play was switched off, the position will no longer correspond to the analogue scale when the digital indicator is
switched on.
To synchronize the analogue and digital display, proceed as follows:
•
Switch off the digital unit via the main switch (H).
Use the adjusting screw (S) to reset the pointer to the original position on the outfeed table.
•
•
Switch on the digital unit again
The digital display has taken over the position of the outfeed table.
Furthermore, the angle for the hollow and pointed joint of the digital display can be calibrated to the zero
point. The procedure for this is described in detail in section 11.2.
BA_PH_335-20_EN_07-22.docx
Clockwise ↻
Counterclockwise ↺
II
I
0
I
II
The analogue scale (A) enables the ex-
A
act setting of the outfeed table. The
current table status is shown on the
digital indicator.
- upwards -
> Pointed joint<
- downwards -
< Hollow joint >
29
Advertisement
Table of Contents
Troubleshooting
