Assembly - Olympus TH4 Instructions Manual

ASSEMBLY

...
²
@
|
³
Fig. 1
† ‡
Fig. 2
1
Connecting the Cables and Cords
ƒ
The cables and cords are vulnerable when bent or twisted. Never
subject them to excessive force.
Make sure that the main switch is set to "
cables and power cord. Otherwise equipment failure may result.
1. Insert the hand switch plug @ into the connector ².
2. Insert the lamp housing plug ³ into the connector |.
Always use the power cord provided by Olympus. If no power cord is
provided with the microscope, please select the proper power cord
by referring to chapter "PROPER SELECTION OF THE POWER SUP-
PLY CORD" at the end of this instruction manual.
3. Insert the power cord plug ƒ into the connector ....
4. Insert the power cord plug † into the wall power outlet ‡.
The power cord should be connected to a grounded, 3-conductor
power outlet. If the power outlet is not grounded properly, Olympus
can no longer warrant the electrical safety performance of the equip-
ment.
If a cable or the power cord comes in contact with the lamp socket or
the surroundings, the cable or cord may melt down, causing electric
shock hazards. Be sure to distribute the cables at enough distance
from the lamp housing and power supply unit.
TH4
(Fig. 1 & 2)
" (OFF) before connecting
6