Inventory - Grizzly ULTIMATE 14" G0555 Owner's Manual

Inventory

The following is a description of the main compo-
nents shipped with your machine. Lay the compo-
nents out to inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Shipping Inventory: (figures 4–6)
A. Bandsaw Assembly .....................................1
B. Upper Stand Braces ....................................2
c. Stand top ....................................................1
D. miter gauge Assembly ................................1
E. Stand Sides .................................................2
f. table w/insert & table pin ..........................1
G. table trunnion .............................................1
h. table lock Knobs
I. lower Stand Braces ....................................2
J. Front Fence rail ..........................................1
K. rear Fence rail ..........................................1
L. Fence Assembly ..........................................1
M. hardware (not Shown):
— hex Bolts m6-1 x 16 (Stand) ................. 16
— Flat Washers 6mm (Stand) ................... 16
— Flange nuts m6-1 (Stand) .................... 16
⁄ "-16 x 2" (Stand) ................ 4
— Stand Feet 3
8
— hex nuts ⁄ "-16 (Stand Feet) .................. 8
3
8
— Flat Washers ⁄ " (Stand Feet) ................ 8
3
8
— Carriage Bolts m8-1.25 x 16 (Stand) ...... 8
— Flange nuts m8-1.25 (Stand) .................. 8
— hex Bolts m8-1.25 x 35 (Bandsaw) ........ 4
— Flat Washers 8mm (Bandsaw) ............... 8
— lock Washers 8mm (Bandsaw) .............. 4
— hex nuts m8-1.25 (Bandsaw) ................. 4
— hex Bolts m8-1.25 x 30 (trunnion) ......... 2
— lock Washers 8mm (trunnion) ............... 2
— hex Bolt m8-1.25 x 80 (positive Stop) .... 1
— hex nut m8-1.25 (positive Stop) ............. 1
— Fence Stand-off m6-1 x 20 (Fence) ....... 1
— lock handle m8-1.25 x 20 (Fence) ......... 1
—Cap Screws m6-1 x 16 Black (Fence) .... 2
— hex Bolts m6-1 x 20 Black (Fence) ........ 2
— lock Washers 6mm Black (Fence) ......... 2
— Flat Washers 6mm Black (Fence) .......... 2
—hex nut m8-1.25 Black (Fence) .............. 1
— hex nut m6-1 Black (Fence)................... 1
-14-
Qty
⁄ "-16 .............................2
3
8
A
figure 4. Bandsaw assembly.
C
d
F
g
h
figure 5. other components.
J
K
figure 6. Fence components.
NOTICE
If you cannot find an item on this list, care-
fully check the machine and the packaging
materials. Some of these items may be pre-
installed for shipping or become misplaced
during unpacking.
model g0555/g0555p (mfg. Since 5/11)
B
e
i
l