Aligning Fence - Grizzly ULTIMATE 14" G0555 Owner's Manual

Aligning fence

to ensure accurate cutting when using the fence,
the face of the fence must be parallel to the table
miter slot and, thus, to the side of the blade.
Tools Needed
hex Wrench 5mm ...............................................1
To align the fence parallel with the miter slot:
1.
make sure the miter slot is parallel with the
blade, as instructed in the previous Aligning
Table procedure.
2.
diSConneCt BAndSAW From poWer!
3.
install the fence on the right side of the blade,
even with the edge of the miter slot, then lock
it in place.
— if the fence is parallel with the miter slot, no
adjustment is necessary.
— if the fence is not parallel with the miter
slot, proceed to Step 4.
-30-
4. loosen the four fence adjustment cap screws
shown in the figure below, adjust the fence
parallel to the miter slot, then re-tighten the
cap screws to secure the setting.
Cap Screws
Qty
figure 41. location of the fence adjustment cap
model g0555/g0555p (mfg. Since 5/11)
screws.