Functional Description - Bosch PROFESSIONAL GSG 300 Operating Instructions Manual

OBJ_BUCH-3 609 929 A20-001.book Page 2 Thursday, July 28, 2005 1:45 PM
e) Maintain power tools with care. Check for
misalignment or binding of moving parts,
breakage of parts, and any other condition
that may affect the tool's operation. If
damaged, have the power tool serviced
before using. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Prop-
erly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g) Use the power tool, accessories, tool bits,
etc., in accordance with these instructions
and in the manner intended for the partic-
ular type of power tool, taking into account
the working conditions and the work to be
performed. The use of power tools for applica-
tions other than intended for can lead to danger-
ous situations.
5) Service
a) Have your power tool serviced/repaired
only by qualified repair personnel and only
using original spare parts. This will ensure
that the safety of the power tool is maintained.
Power Tool-specific
Safety Rules
B Do not work materials containing asbestos.
Asbestos is considered carcinogenic.
B Do not use the power tool with a damaged
cord. Do not touch the damaged cord and pull
the plug from the outlet when the cord is dam-
aged while working. Damaged cords increase
the risk of an electric shock.
B Connect power tools that are used in the open
via a Ground Fault Circuit Interrupter (GFCI).
B Keep hands away from the sawing range. Do
not reach under the workpiece. Contact with
the saw blade can lead to injuries.

Functional Description

Read all instructions. Failure to follow
all instructions listed below may result in
electric shock, fire and/or serious per-
sonal injury.
While reading the operating instructions, unfold the
graphics page for the tool and leave it open.
3 609 929 A20 • 28.7.05
Intended Use
The machine is intended for the cutting of flexible
foamed materials made of plastic, rubber or similar
materials.
Tool Elements
The numbering of the tool elements refers to the illus-
tration of the tool on the graphics page.
1 On/Off switch
2 Saw blade guide*
3 Saw blade pair*
4 Base plate
5 Screw
6 Cover plate
7 Knurled screw
8 Tensioning screw for base plate
*Not all of the accessories described are included as
standard delivery.
Technical Data
Foam rubber cutter
Article number
Rated power input
Output power
Stroke rate at no load
Stroke speed under load
Cutting capacity, max.
Weight according to
EPTA-Procedure
01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltages and models for specific coun-
tries, these values can vary.
Please observe the article number on the type plate of your
power tool. The trade names of individual tools may vary.
Noise/Vibration Information
Measured values determined according to EN 60745.
Typically the A-weighted sound pressure value of the
tool is 79 dB(A). Measuring uncertainty K=3 dB.
The noise level when working can exceed 85 dB(A).
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
English–2
GSG 300
PROFESSIONAL
0 601 575 1..
W 350
W 185
spm 3200
spm 2100
mm 300
kg 1.6
/II
2
.