JVC DLA-X35BE Service Manual page 18

3.2.24 REMOVING THE DD PWB (Fig.3-4)
(1) Remove the 4 screws [G], then remove the DD SHIELD
CASE.
(2) Remove the 4 screws [H], then remove the DD SHIELD
TOP.
(3) Remove the 4 screws [J], then remove the DD PWB.
3.2.25 REMOVING THE BOTTOM DUCT (Fig.3-4)
(1) Remove the 5 screws [K], then remove the BOTTOM
DUCT.
3.2.26 REMOVING THE SHIELD LEFT (Fig.3-4)
(1) Remove the 3 screws [L], then remove the SHIELD LEFT.
MOTOR PWB
F F
J J
DD SHIELD BOTTOM
C C
D D
CONNECTOR BRACKET
TEMP SENSOR
B B
A A
LAMP COOLING FAN
EXHAUST DUCT FAN
L L
SHIELD LEFT
3.2.27 REMOVING THE LD PWB (Fig.3-5)
(1) Remove the 3 screws [A], then remove the LD PWB.
3.2.28 REMOVING THE PROCESSOR PWB (Fig.3-5)
1-18 (No.PA045<Rev.001>)
J J
G G
DD PWB
DD SHIELD TOP
E E
CONNECTOR
OPTICAL BLOCK
K K
BOTTOM DUCT
Fig.3-4
(1) Remove the 6 screws [B], then remove the PROCESSOR
PWB.
3.2.29 REMOVING THE DD COOLING FAN (Fig.3-5)
(1) Remove the 3 screws [C], then remove the DD COOLING
FAN UNIT.
(2) Remove the 3 screws [D], then remove the DD COOLING
FAN.
3.2.30 REMOVING THE DD SUB PWB (Fig.3-5)
(1) Remove the 4 screws [E], then remove the DD SUB PWB.
3.2.31 REMOVING THE MD PWB (Fig.3-5)
(1) Remove the 4 screws [F], then remove the BRACKET.
(2) Remove the 8 screws [G], then remove the MD SHIELD
TOP.
(3) Remove the 6 screws [H], then remove the MD PWB (TOP/
BOTTOM).
3.2.32 REMOVING THE CW PWB (Fig.3-5)
(1) Remove the 4 screws [J], then remove the CW PWB.
3.2.33 REMOVING THE SHIELD RIGHT (Fig.3-5)
(1) Remove the 6 screws [H], then remove the SHIELD
RIGHT.
H H