Installation Instructions - Jocel JCH-100 Instruction Manual

1. Failure to comply with the above instructions could result in damage occurring to the
appliance. The manufacturer will not be held responsible if these instructions are
disregarded.
2. The appliance must be protected against rain, moisture and other atmospheric influences.
 IMPORTANT: Care must be taken while cleaning/carrying the appliance to avoid touching
the condenser metal wires at the back of the appliance, as you might injure your fingers
and hands or damage your product.
 IMPORTANT: This appliance is not designed for stacking with any other appliance. Do not
attempt to sit or stand on top of your appliance as it is not designed for such use. You
could injure yourself or damage the appliance.
 IMPORTANT: Make sure that mains cable is not caught under the appliance during and
after carrying/moving the appliance, to avoid the mains cable becoming cut or damaged.
When positioning your appliance take care not to damage your flooring, pipes, wall
coverings etc. Do not move the appliance by pulling by the lid or handle. Do not allow
children to play with the appliance or tamper with the controls. Our company declines to
accept any liability should the instructions not be followed.

INSTALLATION INSTRUCTIONS

1. If possible, avoid placing the appliance near cookers, radiators or in direct sunlight as this
will cause the compressor to run for long periods. If installed next to a source of heat or
refrigerator, maintain the following minimum side clearances:
From Cookers
From Radiators
From Fridges
2. Make sure that sufficient room is provided around the appliance to ensure free air
circulation. Ideally, A space of no less than 10cm must be left around the freezer, and
ensure you allow gaps as shown in the below diagram.
3. The appliance should be located on a smooth surface.
4. It is forbidden to use the refrigerator outdoors.
5. Protection from moisture. Do not locate the freezer in moist space to avoid the metal parts
rusty. And do not spray water to the freezer, otherwise it will weaken the insulation and
causes current leakage.
6. Refer to "Cleaning and Care" section to prepare your appliance for use.
7. If the freezer is installed in unheated areas, garages etc., in cold weather condensation
may form on the outer surfaces. This is quite normal and is not a fault. Remove the
condensation by wiping with a dry cloth.
STARTING
Final Check
Before you starting to use the freezer, please check that:
4" (100 mm)
12" (300 mm)
4" (100 mm)
29